1-1/4" Quick Release Brick Mortar Removal Blade

More Views

1-1/4" Quick Release Brick Mortar Removal Blade

This 1-1/4 inch wide extended length Carbide Grit Tipped Blade is designed to facilitate the removal of embedded mortar around a standard clay brick. Will also cut into surfaces such as stucco, Hardie Board, concrete board and thin-set cements.

Sku: Q1164

  | 

Availability: Sold Out

Regular Price: US $18.99

Special Price US $11.99

  • Buy 3 for US $10.99 each and save 9%
  • Buy 10 for US $9.99 each and save 17%
  • Buy 30 for US $8.99 each and save 26%

Additional Information

Best for cutting Deep reaching brick mortar removal
Blade Width 1-1/4 inch X .11" carbide grit thickness
Material Electroplated Carbide Grit
TPI (Teeth Per Inch) 30 grit
Plunge Depth 3.88 inch

Do you need to remove or replace a standard size clay brick without disturbing the surrounding good bricks?  Then this new Brick Mortar Removal cutter is just for you.

The design of this new blade facilitates deep plunges and linear cutting around bricks to progressively clear away the holding mortar.

This extended length carbide-grit tipped blade can plunge up to 3-7/8 inches deep.

WARNING: Please take note: This extra long cutter is only recommended for very experienced multi-tool users. Longer blades put higher working loads on your multi-tool. Please listen to your machine when using this cutter to avoid motor stalls or total burnout failure.

Special Alert for Bosch MX30E & MXH180B model owners: Please be aware that this item and any of our other 'Quick Release' accessories, will NOT suitably lock-fit onto your Bosch Tool-less Blade change multi-tool model without our C-Clip Adapter.

Special Alert for Dremel MM40, MM45 & MM50 model owners: Please be aware that this item and any of our other 'Quick Release' accessories, will NOT suitably lock-fit onto your Dremel Tool-less Blade change model without our C-Clip Adapter.

Special Alert for Black & Decker 'Matrix' & Craftsman 'Bolt-On' model owners: Please be aware that this item will NOT suitably pin-lock into your cordless multi-tool head.

Special Alert for new Bosch StarLock & Fein StarLock model owners: Please be aware that this item and any of our other accessories, will NOT fit your 2016 or newer machines if utilizing the new 'bottle-cap' style blade anchoring system.

These blades or attachements are compatible with the following machines:

  • Craftsman (all models except 'Bolt-On')
  • DeWalt
  • Dremel MM40, MM45 & MM50 with our C-Clip Adapter
  • Dremel Velocity & MM35
  • Genesis all models (with blade change lever)
  • Green Tech Power Multitool
  • Hercules 3.5 amp Multi-Tool
  • Integra PRO Multi Tool
  • Kobalt Oscillating Tool Kit
  • Mastercraft Maximum Multi-tool
  • Parkside PMFW 310 C2 (with blade change lever)
  • Porter Cable all models (round or square blade pins)
  • Rockwell Hyperlock
  • Triton Multi-Tool
  • Worx Hyperlock
  • Black & Decker
  • Stanley Fatmax
Quick Release Hybrid design also compatible with:
  • Most Multi-Fit Standard listed machines